Icom IC-775DSP Instruction Manual page 57

W Scan edge memory channels
Memory channels P1 and P2 are scan edge memory
channels. These memory channels are used to
program scan edge frequencies for programmed
scan. (p. 54)
e Scan edge memory channel selection
You can transmit and receive using the programmed.
frequency and operating mode in the. scan edge
memory channels.
e Scan edge memory channel
programming
A scan edge memory channel can be programmed
in either the VFO or memory mode the same way as
regular memory channel programming.
@ Set 28.000 MHz in the VFO mode.
-An operating mode can also be programmed,
however, the programmed operating mode does not
affect programmed scan.
Select the scan edge memory channel P1 with
MAIN [M-CH UP]/[M-CH DOWN].
Push [MW] for 2 sec. to program 28.000 MHz
into the scan edge memory channel P1.
MAIN M-CH MAIN M-CH
Ceo) ° Coe)
edge memory channel, P2.
into the scan edge memory channel P2.
DOWN].
52