Icom IC-775DSP Instruction Manual page 59

Mi Programmed scan operation
@ Select the VFO mode.
@) Select the desired operating mode.
- The operating mode can also be changed while
scanning.
@) Set [SQL] open or closed.
- See page at left for scan condition.
@ Push [SCAN] to start the scan.
- Decimal points blink while scanning.
©) When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume
setting and the squelch condition.
oe During scan the [TS] switch can be used.
© To cancel the scan, push [SCAN].
NOTE: If the same frequencies are programmed
into the scan edge memory channels P1 and P2,
programmed scan does not start.
W Memory scan operation
@ Select the memory mode.
@ Close the squelch with [SQL].
@) Push [SCAN] to start the scan.
- Decimal points blink while scanning.
@ When the scan detects a signal, the scan stops
or pauses depending on the scan resume set-
ting.
©) To cancel the scan, rotate the main dial, or push
[SCAN].
NOTE: 2 or more memory channels must be
programmed for memory scan to start.
li Select memory scan operation
@ Select the memory mode.
@) Close the squelch with [SQL].
© Push [SCAN] to start the memory scan.
- Decimal points blink while scanning.
@ Push [SEL] to activate the select memory scan.
- " (setect)" continuously lights during select memory
scan.
(©) When the scan detects a signal, the scan stops
or pauses depending on the scan resume set-
ting.
To cancel the scan, rotate the main dial, or push
[SCAN].
NOTE: 2 or more memory channels must be
designated as select memory channels for select
memory scan to start.
SCANS 7 |
@ Select the
VFO mode.
@ Start.
©Stop.
@Set squelch. @Select operating mode.
[DISPLAY EXAMPLE DURING A SCAN]
Decimal points blink.
@ Select the — @Start.
@Close squelch. 'memory mode. @©)Stop.
@ Select the
memory mode.
@ Start select
@Close squelch. memory scan.
Se WC ECH
oOOOuOOk
Decimal points blink. E " lights.