Icom IC-775DSP Instruction Manual page 54

D MEMORY CHANNELS
Mi Memory channels
The transceiver has 101 memory channels. The
memory mode is very useful for quickly changing to
often-used frequencies.
D
NOTE: During dualwatch or split frequency opera-
tion, the programmed memory channel contents
an be called up for the SUB readout.
WWW
All 101 memory channels are tunable which means
the programmed frequency can be tuned temporarily
with the main dial, etc. in the memory mode.
Regular memory One frequency and one mode in
channels each memory channel.
Scan edge One frequency and one mode in
memory each memory channel as scan
channels edges for programmed scan.
Mi Memory channel selection
@ Push MAIN [VFO/MEMO] to select the memory
mode.
- "MEMO" appears.
CG) Push MAIN [M-CH UP]/[M-CH DOWN] several
times to select the desired memory channel.
- [UP] and [DN] on the microphone also select the
programmed memory channels in memory mode.
@) To return to the VFO mode, push MAIN
[VFO/MEMO] again.
MAIN M-CH
WE Memory clearing
Any unnecessary memory channels can be cleared.
The cleared memory channels become blank chan-
nels. |
@ Select the memory mode with MAIN SS
[VFO/MEMO]. i oP
@ Select a memory channel to be cleared with | ~ eager? Push for 2 sec.
MAIN [M-CH UP]/[M-CH DOWN].
@) Push [CLEAR] for 2 sec. to clear the contents. MEMO
- The programmed frequency and operating mode Oren
disappear and "(Biak)" appears. .
@ To clear other memory channels, repeat steps ©
and @).