Icom IC-775DSP Instruction Manual page 50

D SET MODE
(5) Scan speed "SC-SPd"
The transceiver has 2 speeds for scanning, high and
low.
(6) Microphone up/down speed "UP-SPd"
When you push and hold the microphone [UP]/
[DOWN] switches, you can change the frequency
continuously.
You can select high or low speed tuning for the
microphone [UP]/[DOWN] switches.
(7) Memo pad capacity "PAd-CH"
You can select the number of memo pads, 5 or 10,
for your convenience.
(8) Antenna switches "Ant-SEL"
You can set the antenna connector selection to
automatic, manual or non-selection (when using 1
antenna only).
When "Aut" is selected, the [ANT1]/[ANT2] switches
are activated and the band memory memorizes the
selected antenna. See p. 39 for details.
When "on" is selected, the [ANT1]/[ANT2] switches
are activated and select an antenna manually. .
When "oFF" is selected, the [ANT1]/[ANT2] switches
are not activated and do not function. The [ANT1]
connector is always selected in this case.
SC -5P d
High speed (default)
Low speed
Hi Ud -5P
Low speed (25 tuning steps/sec.)
5 memo pad (default)
10 memo pad
(i Aint -S
Antenna switches Auto (default)
Antenna switches O
Antenna switches OFF
d
C