Icom IC-775DSP Instruction Manual page 56

6 MEMORY CHANNELS
W Frequency transferring
The frequency and operating mode in the memory
mode can be transferred to the VFO mode.
e Transferring in the VFO mode
This is useful for transferring programmed contents
to VFO.
@ Select VFO mode with MAIN [VFO/MEMO].
CG) Select a memory channel with MAIN IN. GH UP]/
[M-CH DOWN].
-To confirm the memory channel contents, push
MAIN [VFO/MEMO]; then push MAIN [VFO/MEMO]
again to return to the VFO mode.
- "(tank)" appears if the selected memory channel is
a blank channel (and does not have contents). In
this case transferring is impossible.
@) Push [MV] for 2 sec. to transfer the frequency
and operating mode.
- Transferred frequency and operating mode appear
on the display.
e Transferring in the memory mode
This is useful for transferring frequency and oper-
ating mode while operating in the memory mode.
NOTE: When you have changed the frequency or
operating mode in the selected memory channel:
- Displayed frequency and mode are transferred.
- Programmed frequency and mode are not
transferred, and they remain in the memory
channel.
@ Select a memory channel with MAIN [M-CH UP]/
[M-CH DOWN] in the memory mode.
- And, set the frequency or operating mode if required.
(2) Push [MPV] for 2 sec. to transfer the frequency
and operating mode.
- Displayed frequency and operating mode are trans-
ferred to the VFO.
@ To return to the VFO mode, push MAIN
[VFO/MEMO]. —
e Transferring in the VFO mode during
split frequency operation
OU Select a memory channel with SUB [M-CH UP}/
[M-CH DN] in the VFO mode.
- To confirm the memory channel contents, push SUB
[VFO/MEMO}; then push SUB [VFO/MEMO] again to
return to the VFO mode.
- A blank channel cannot be transferred.
@) While pushing [XFC], push [M>V] for 2 sec. to
transfer the frequency.
- Transferred frequency appear in the SUB readout.
The frequency tranferring can be performed in either
the VFO mode or in the memory mode.
TRANSFERRING EXAMPLE IN THE VFO MODE
Operating frequency : 21.320 MHz/USB (VFO)
Contents of MEMO 16 : 14.020 MHz/CW
MAIN M-CH MAIN M-CH
Ce Ces"
Ste Push for 2 sec.
TRANSFERRING EXAMPLE IN THE MEMORY MODE
Operating frequency : 14.028 MHz/CW (MEMO 19)
o?
Sie obop Push for 2 sec.
e Transferring in the memory mode
during split frequency operation
© Select a memory channel with SUB [M-CH_UP]/
[M-CH DN] in the memory mode.
- And, set the frequency if required.
@ While pushing [XFC], push [MV] for 2 sec. to
transfer the frequency.
-Displayed frequency is transferred to the SUB
readout VFO.
@) To return to the VFO mode,
push SUB
[VFO/MEMO]. )