Table of Contents
Advertisement
MultiVOIP Quick Start Guide
Configuring Your MultiVOIP
The following steps provide instructions for configuring your
MVP120. The configuration sequence includes IP Protocol
default setup, Channel setup, and Phone Directory Database
setup. The Phone Directory Database setup is configured
differently depending on whether or not the Gatekeeper
function is available and enabled on the Phone Directory
Database dialog box.
1. The IP Protocol Default Setup dialog box displays.
The default Frame Type is TYPE_II. If this does not match
your IP network, change the Frame Type by selecting
SNAP from the Frame Type list. The available Frame
Type choices are TYPE_II and SNAP.
2. In the Ethernet group, enter the IP Address, Subnet
Mask, and Gateway Address unique to your IP LAN. The
IP address is the unique LAN IP address assigned to the
MVP120. The Gateway address is the IP address of the
device connecting your MVP120 to the Internet. Click OK
when you are finished.
3. The Channel Setup dialog box displays. The four tabs in
this dialog box define the channel interface, voice/fax
parameters, billing/miscellaneous parameters, and
regional telephone parameters.
16
Advertisement
Table of Contents
