Table of Contents
Advertisement
Configuring the MultiVOIP
Check with your in-house phone personnel to verify
whether your local PBX dial signaling is Pulse or DTMF
(tone). Select the Regeneration option accordingly.
The Inter Digit Time option defines the maximum amount
of time between dialed digits that the unit will wait before
mapping the dialed digits to an entry in the Phone
Directory Database. If too much time elapses between
digits, the wrong number will be mapped and you will hear
a rapid busy signal. If this happens, hang up and dial
again. The default setting is 2 seconds.
In the Flash Hook Timer box, enter the amount of time for
the duration of the flash hook signals output on the FXO
interface. The default setting is 600 milliseconds.
The Message Waiting Light check box must be selected
on the originating and answering voice channel. This
enables the number dialed to connect you to the
appropriate voice channel, then output that number on the
voice channel.
17
Advertisement
Table of Contents
