Table of Contents
Advertisement
MultiVOIP Quick Start Guide
The Message Waiting Light check box must be selected
on the originating and answering voice channel. This
enables the number dialed to connect you to the
appropriate voice channel, then output that number on the
voice channel.
For FXO-to-FXO communications, you can enable a
specific kind of FXO disconnect: Current Loss, Tone
Detection, or Silence Detection. Check with your in-
house phone personnel to verify the type of disconnect to
use. If Current Loss is checked, the VOIP will hangup
when it detects a loss of current on the FXO (phone) port.
For tone detection, select from the lists one or two tones
that will cause the line to disconnect. The person hanging
up the call must then press the key or keys that produce
those tones to hangup a call. For silence detection, select
One Way or Two Way, then set the timer for the number
of seconds of silence before disconnect. The default value
of 15 seconds may be shorter than desired for your
application.
7. The Voice/Fax tab displays the parameters for the voice
gain, DTMF (Dual Tone Multi-Frequency) gain, voice
coder, faxing, and advanced features such as Silence
Compression, Echo Cancellation, and Forward Error
Correction.
38
Advertisement
Table of Contents
