Phase 1: Configuring Your Master Multivoip; Software Loading - Multitech MVP200 Quick Start Manual

MultiVOIP Quick Start Guide

Phase 1: Configuring Your Master MultiVOIP

Configuring your Master MultiVOIP involves software loading
and configuration.

Software Loading

The software loading procedure does not provide every screen
or option in the loading process. It is assumed that a technical
person with a thorough knowledge of Windows and the
software loading process is performing the installation.
Additional information on the MultiVOIP software is provided in
the User Guide supplied with your MultiVOIP.
If you are installing a MultiVOIP behind a firewall, you need to
add the following UDP ports to your firewall.
Q.931 Signaling, Ch1 [900]
Status [5000]
Ch1 RTP [5004]
Ch2 RTP [5006]
Refer to your firewall user documentation to enter and open
these ports.
1 Run Windows on the PC connected to the MultiVOIP.
2 Insert the MultiVOIP diskette labeled Disk 1 into the disk
drive on the PC connected to the MultiVOIP.
Win3.1 users - in Program Manager, click File | Run. In
3
the Run dialog box, type a:\setup or b:\setup (depending
on the location of your floppy disk drive) in the Command
Line field and then click OK.
Win95/98/NT users - click Start | Run. In the Run dialog
box click the down arrow and choose a:\setup or b:\setup
(depending on the location of your floppy disk drive), then
click OK.
14
Q.931 Signaling, Ch2 [902]
Ch1 RTCP [5005]
Ch2 RTCP [5007]