Table of Contents
Advertisement
MultiVOIP Quick Start Guide
Configuring the Host MultiVOIP
The following steps provide instructions for configuring your
MVP120. The configuration sequence includes IP Protocol
default setup, Channel setup, and Phone Directory Database
setup.
12. The IP Protocol Default Setup dialog box displays.
The default Frame Type is TYPE_II. If this does not match
your IP network, change the Frame Type by selecting SNAP
from the Frame Type list. The available Frame Type choices
are TYPE_II and SNAP.
13. In the Ethernet group, enter your unique LAN IP address in
the IP Address box, then enter the Subnet Mask and
Gateway Address for your LAN in the corresponding
boxes.
The IP address is your unique LAN IP address, and the
Gateway address is the IP address of the device
connecting your MultiVOIP to the Internet.
Click OK when you are finished.
14. The Channel Setup dialog box displays. The four tabs in
this dialog box define the channel interface, voice/fax
parameters, billing/security parameter, and regional
telephone parameters (tone pairs).
16
Advertisement
Table of Contents
