Phase 1: Configuring Your Master Multivoip - Multitech MVP400 User Manual

MultiVOIP User Guide

Phase 1: Configuring Your Master MultiVOIP

The following software loading procedure does not provide every screen or option in the loading
process. The assumption is that a technical person is doing the installation and that a thorough
knowledge of Windows and the software loading process is understood. Additional information on
the MultiVOIP software is provided in the User Guide supplied with
your MultiVOIP.
If you are installing a MultiVOIP behind a firewall, you need to add the following UDP ports to your
firewall.
Q.931 Signaling, Ch1[900]
Q.931 Signaling, Ch3[904]
Q.931 Signaling, Ch5[908]
Q.931 Signaling, Ch7[912]
Status [5000]
Ch1 RTP [5004]
Ch2 RTP[5006]
Ch3 RTP[5008]
Ch4 RTP[5010]
Ch5 RTP[5012]
Ch6 RTP[5014]
Ch7 RTP[5016]
Ch8 RTP[5018]
Refer to your firewall user documentation to enter and open these ports.
1 Run Windows on the PC connected to the Command Port.
2 Insert the MultiVOIP diskette labeled Disk 1 into the disk drive on the PC connected to the
Command port.
3 Win3.1 users - in Program Manager, click File | Run. In the Run dialog box, type a:\setup
or b:\setup (depending on the location of your floppy disk drive) in the Command Line field
and then click OK.
Win95/NT users - click Start | Run. In the Run dialog box click on the down arrow and
choose a:\setup or b:\setup (depending on the location of your floppy disk drive) and in the
Command Line field and then click OK.
4 The Welcome screen is displayed.
Click Next to continue.
22
Q.931 Signaling, Ch2 [902]
Q.931 Signaling, Ch4 [906]
Q.931 Signaling, Ch6 [910]
Q.931 Signaling, Ch8 [914]
Ch1 RTCP [5005]
Ch2 RTCP [5007]
Ch3 RTCP [5009]
Ch4 RTCP [5011]
Ch5 RTCP [5013]
Ch6 RTCP [5015]
Ch7 RTCP [5017]
Ch8 RTCP [5019]