Rack Installation - Extreme Networks Summit Summit1i Hardware Installation Manual

Rack Installation

To mount the Alpine 3800 series chassis into a standard 19-inch (48.26 cm) rack, you need the following
tools, equipment, and resources:
• Helper bracket (provided)
• A minimum of four appropriate screws to secure the helper bracket (not provided)
• If you have an Alpine 3808 or 3804, a minimum of eight appropriate screws (not provided) to secure
the chassis into the rack
• If you have an Alpine 3802, a minimum of four appropriate screws (not provided) to secure the
chassis into the rack
• # 1 Phillips screwdriver
• A minimum of two people to help install the chassis into the rack
To mount the chassis into a rack:
1 Mount the helper bracket in the lowest available position in the rack using four appropriate screws
(not provided), as shown in Figure 50.
Figure 50: Helper bracket for mounting the Alpine 3800 series chassis
2 Place the box that contains the chassis upright on a secure flat surface with the front of the box
facing you.
3 Remove the chassis from the box, and remove the packing material from the chassis.
4 Have a minimum of two people lift and place the empty chassis on the helper bracket and slowly
guide the chassis into the rack.
Extreme Networks Consolidated "i" Series Hardware Installation Guide
Installing the Chassis
BDbrackt
119