Extreme Networks Summit Summit1i Hardware Installation Manual page 246

BlackDiamond 6800 Series I/O Modules
NOTE
If congestion is detected on a port with flow control enabled, a flow control PAUSE frame is sent out
that port. The PAUSE frame is not sent out on the other port in the group.
3
The G24T module supports distances of up to 100 meters over CAT 5 cabling.
LEDs
The G24T 3 module has the following LEDs:
• Module status
• Port status
• Diagnostics
For information about the LEDs and their activity on the G24T
page 267.
Software Requirements
3
The G24T module requires that you load ExtremeWare version 7.0.1b5 or later and BootROM 7.8 or
later on the switch.
Hardware Requirements
3
The G24T requires a BlackDiamond chassis using MSM switch fabric module(s).
Use iPower power supplies (part numbers 50020, 50021, 50022) with G24T
chassis with original power supplies (part number 50012) will not support a chassis fully populated
3
with G24T modules.
Table 75 lists the number of G24T
on which power supplies are installed.
3
Table 75: G24T modules supported
Chassis
BlackDiamond 6804
BlackDiamond 6808
BlackDiamond 6808
BlackDiamond 6816
246
3 modules that you can install in a BlackDiamond chassis depending
Power Supply
any
original power supplies
iPower power supplies
iPower power supplies
3 module, see "I/O Module LEDs" on
3 modules. A BlackDiamond
3
G24T Module
4
5
7
15
Extreme Networks Consolidated "i" Series Hardware Installation Guide