Wm-1T3I Module; I/O Module Leds - Extreme Networks Summit Summit1i Hardware Installation Manual

Configuring I/O Modules

WM-1T3i Module

Figure 85 shows the WM-1T3i module.
Figure 85: WM-1T3i module
Module reset button
Module status T3 port 10/100 Mbps ports
LEDs
38_WM1T3i
The WM-1T3i module has one T3 port, consisting of a two BNC connectors, one for the transmit path
and one for the receive path. The module also has two general purpose 10/100 Ethernet ports, using
standard RJ-45 connectors. The WM-1T3i also has eight internal loopback ports that allow you to
configure bi-directional rate-limiting without tying up any of the external ports for ingress rate shaping.
Internal loopback ports are marked with the notation "iL" when displayed on the command line or
with ExtremeWare Vista Web access.
For the WM-1T3i module, use RG-59 75 ohm coax cable.
LEDs
The WM-1T3i module has the following LEDs:
• Module status
• Port status
For information about the LEDs and their activity on the WM-1T3i module, see "I/O Module LEDs" on
page 175.
Software Requirements
The WM-1T3i module requires ExtremeWare version 6.1.5 or later and BootROM 6.5 or later.
For more information about software requirements and WM-1T3i module configuration, see the
ExtremeWare Software User Guide and the ExtremeWare Command Reference Guide.

I/O Module LEDs

Table 56 describes the LED activity on the Alpine I/O modules with the green stripe (for example, the
GM-4Ti, GM-4Xi, and FM-24MFi I/O modules).
Table 57 describes the LED activity on the Alpine Access I/O modules with the silver stripe (for
example, the WM-4T1i, WM-4E1i, and WM-1T3i I/O modules).
Table 58 describes the system LED activity on the Alpine PoE modules (for example, the FM32Pi I/O
module). Both system and per-port LEDs are present on the module under software control.
Table 59 describes the port LED activity on the Alpine PoE modules (for example, the FM32Pi I/O
module). The per-port LEDs indicate link status and power status with the scheme shown in Table 59.
Extreme Networks Consolidated "i" Series Hardware Installation Guide 175