Appendix C: Optional Rack Mount Rail Kit Installation; Required Tools - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

C
Optional Rack Mount Rail Kit
Installation

Required Tools

Installation Site Requirements
Contents of the Mounting Kit
Removing the Rack Mount Ears from the SSA Switch
Installing the Adapter Plates
Four-Post Rack Mount Installation
Two-Post Rack Mount Installation
This appendix describes the installation and use of the optional SSA Universal Rack Mount kit, model
number SSA-FB-MOUNTKIT. This optional rack mounting kit provides for flexible mounting options in
both four-post and two-post rack installations.
Warning
Electrical hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Risques d'électrocution: Seul un personnel qualifié doit effectuer les procédures d'installation.
Begin by reviewing
check Contents of the Mounting Kit
To perform the installation, follow these steps in order:
1 Remove the rack mount ears from the chassis.
See Removing the Rack Mount Ears from the SSA Switch
2 Attach the adapter plates to the chassis.
See Installing the Adapter Plates
3 Install the rail assemblies in either a four-post or two-post rack, and install the chassis in the rack..
See Four-Post Rack Mount Installation
59 .
Required Tools
Use the following tools to install the optional SSA Universal Rack Mount kit:
•
ESD wrist strap (included with the SSA chassis)
•
Phillips screwdriver
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
Required Tools on page 52 and
on page 53 to verify that your kit contains all of the required parts.
on page 54.
on page 56 or
Installation Site Requirements
on page 54.
Two-Post Rack Mount Installation
on page 53. Then,
on page
52