Removing A Blackdiamond 6800 Series Fan Tray - Extreme Networks Summit Summit1i Hardware Installation Manual

BlackDiamond 6800 Series Switch Fan Tray
Figure 139: BlackDiamond 6804 fan tray
Turn screw heads
clockwise to lock &
counter-clockwise
to unlock fan tray
Hand
grip

Removing a BlackDiamond 6800 Series Fan Tray

BlackDiamond 6800 series fan trays are hot-swappable. You do not need to turn off power to a
BlackDiamond 6800 series switch to remove a fan tray.
You need the following tools and equipment to remove a fan tray:
• ESD-preventive wrist strap
• # 1 Phillips screwdriver
CAUTION
Only trained service personnel should perform service to BlackDiamond fan trays. Before installing or
removing any components, or carrying out any maintenance procedures, see Appendix A.
To remove a fan tray from the BlackDiamond 6800 series switch:
1 Attach the ESD strap that is provided to your wrist and connect the metal end to the ground
receptacle that is located on the top-left corner of the switch front panel.
2 For the BlackDiamond 6816 switch or the BlackDiamond 6804 switch, use a #1 Phillips screwdriver
to unscrew the two screws that secure the fan tray on the front of the chassis.
For the BlackDiamond 6808 switch, use a #1 Phillips screwdriver to unscrew the ten screws that
secure the fan tray to the rear of the chassis. Put the screws aside in a safe place.
276
Direction
of airflow
XM_030
Extreme Networks Consolidated "i" Series Hardware Installation Guide