Memory Scan; Memory $Сам; Selected Mode Memory 5Сам - Icom IC -765 Instruction Manual

9-3 MEMORY SCAN
9-4 SELECTED MEMORY SCAN
(Меһ2) — Meh D
Micha - -Meh D
[SELECT] [SCAN]
SCANNING OPERATION О
1) Program the desired frequéncies into memory channels.
See p. 37 for programming memory channels.
2) Push the [VFO/MEMO] switch to select MEMORY
mode.
3) Adjust the [SQL] control to the threshold point.
e The green [RECEIVE] indicator goes out.
4) Push the [SCAN] switch.
e "SCAN" lights.
e The scan stops when a receive signal opens the squelch.
e The scan resumes after the signal disappears.
5) To change the scan speed or scan resumption, see Section
11-5.
6) Push the [SCAN] switch again to cancel the scan.
e Some switches also stop the scan. See the diagram on
p. 39.
1) Program the desired frequencies into memory channels.
See p. 37 for programming memory channels.
2) Program the desired memory channels for the selected
memory channel. See p. 36 for Section 8 - 3 itsm (2).
3) Push the [VFO/MEMO] switch to select MEMORY
mode.
4) Adjust the [SOL] control to the threshold point.
e The green [RECEIVE] indicator goes out.
5) Push the [SCAN] switch to start the memory scan.
e "SCAN" lights.
6) Then push the [SELECT] switch to start the selected
memory scan.
e The scan stops when a receive signal opens the squelch.
e The scan resumes after the signal disappears.
7) To change the scan speed or scan resumption, see Section
11-5.
8) To change the scan from the selected memory scan to
the memory scan, push the [SELECT] switch again.
9) To cancel the scan, push the [SCAN] switch again.
e Some switches also stop the scan. See the diagram on
p. 39.