Connecting The Ан-2А; Controller Unit; Data Communications - Icom IC -765 Instruction Manual

SYSTEM INTERCONNECTIONS 4.
4-2 CONNECTING THE AH-2a The AH-2a HF AUTOMATIC ANTENNA TUNER matches
анаа енн a long wire antenna with the IC-765.
ON i ON 2 1) Set s-1 ~ s-6 on S36 and s-6 on S37 address switches in
І [| I D g I
[| [] I | ' 1
the positions shown
at left.
See p. 52 for the address
123456 123456 switch locations.
e Setting when connecting the АН-2а 2) Connect cables as shown in the diagram below.
4 vice Жаныл Address : 04H
e Using the Icom АН-2а
To 13.8 V DC OUTPUT JACK
(1C-765)
2 . |AH-2a
= | | CONTROLLER UNIT
€ (7-PIN DIN PLUG)
Ә
АН-2а
TUNER UNIT
Ə
Li COAXIAL CABLE
CONTROL CABLE
AH-2a
CONTROLLER UNIT
To ANTENNA CONNECTOR COAXIAL CABLE (REAR PANEL)
(ІС-765)
4-3 DATA COMMUNICATIONS
eUSING THE ACC(1) SOCKET
When operating AFSK, AMTOR or packet, connect
external equipment to the ACC(1) socket on the rear
panel or MIC CONNECTOR on the front panel.
In addition, read the instruction manual of an external
unit for the connection.
P |
AFSK
TERMINAL
UNIT
болош
AFSK output
AF input
PTT
Ground Н5-232С
Squelch input
®
©
(>)
©
©