Memory Channel Operation; Memory Снамме1$5; Vfo And Memory Mode Selection; Memory Неапімс - Icom IC -765 Instruction Manual

| ЕШ
MEMORY CHANNEL OPERATION © ІШ
8-1 MEMORY CHANNELS
8-2 VFO AND MEMORY MODE
SELECTION
[VFO/MEMO]
8-3 MEMORY READING
(1) SELECTING A MEMORY CHANNEL
(2) PROGRAMMING A MEMORY CHANNEL
AS A SELECTED MEMORY CHANNEL
[VFO/MEMO] [SELECT]
[MEMORY-CH]
The ІС-765 has 101 memory channels for memory channels
1 ~ 99, P1 and P2. Each memory channel has special
capabilities as shown in the following table:
MEMORY CHANNEL
— NUMBER ` |
One frequency and one mode
1— 89 |
in each memory channel.
Independent transmit and re-
ceive frequencies and mode on
each channel for split operation.
NOTE:
It is possible to use these chan-
nels as normal memory channels.
One frequency and one mode
Р1 and Р2 оп еасһ тетогу сһаппе! а5
scan edges of Programmed Scan.
Pushing the [VFO/MEMO] switch each time alternately
selects VFO and MEMORY mode.
eVFO mode eMEMORY mode
Either "VFO A" or "VFO B"
lights.
"МЕМО" lights.
1
м
Push the [VFO/MEMO] switch to select MEMORY
mode.
e "MEMO" lights.
2
—
Rotate the [MEMORY-CH] selector to select a desired
memory channel.
eWhen memory channels not yet programmed are
selected, only the decimal points appear.
3) To select only the selected memory channels, push the
[SELECT] switch. See item (2) below for programming.
When programming a memory channel as a selected memory
channel, only the selected memory channels are recalled.
1) Push the [VFO/MEMO] switch to select MEMORY
mode.
2) Rotate the [MEMORY-CH] selector to select a desired
memory channel you want to program as a selected
memory channel.
3) Push the [SELECT] switch.
eThe green indicator lights up, indicating that the
channel is a selected memory channel.
4) To cancel the selected memory channel, push the
[SELECT] switch again.