Displaying Ethernet Oam Protocol Information - Cisco Catalyst 4500 series Administration Manual

Chapter 66 Configuring Ethernet OAM and CFM

Displaying Ethernet OAM Protocol Information

To display Ethernet OAM protocol information, you can use the privileged EXEC commands in
Table
Table 66-4 Displaying Ethernet OAM Protocol Information
Command
show ethernet oam discovery [interface
]
interface-id
show ethernet oam statistics [interface
]
interface-id
show ethernet oam status [interface
]
interface-id
show ethernet oam summary
These examples show how to apply these commands:
Switch# show ethernet oam discovery
GigabitEthernet1/1
Local client
------------
Administrative configurations:
Operational status:
Remote client
-------------
MAC address: 000f.8f03.3591
Vendor(oui): 00000C(cisco)
Administrative configurations:
Switch# show ethernet oam statistics
GigabitEthernet1/1
Counters:
---------
Information OAMPDU Tx
Information OAMPDU Rx
Unique Event Notification OAMPDU Tx
OL-28731-01
66-4.
Mode: active
Unidirection: not supported
Link monitor: supported (on)
Remote loopback: supported
MIB retrieval: not supported
Mtu size: 1500
Port status: operational
Loopback status: no loopback
PDU revision: 10
PDU revision: 2
Mode: active
Unidirection: not supported
Link monitor: supported
Remote loopback: supported
MIB retrieval: not supported
Mtu size: 1500
Purpose
Displays discovery information for all Ethernet OAM interfaces or
the specified interface.
Displays detailed information about Ethernet OAM packets.
Displays Ethernet OAM configuration for all interfaces or the
specified interface.
Displays active Ethernet OAM sessions on the switch.
: 101163
: 51296
: 0
Software Configuration Guide—Release IOS XE 3.6.0E and IOS 15.2(2)E
Displaying Ethernet OAM Protocol Information
66-49