Table of Contents
Advertisement
Ports Setup
Select the port you want to configure by clicking on the port
in the Switch front panel display at the top of the screen or
by using the screen displayed above. Follow these steps:
1. Enable or disable the port. If you choose Disabled, devices
connected to that port cannot use the Switch, and the
Switch purges their addresses from its address table after
the MAC address aging time elapses. The Switch won't
purge addresses if you define them as permanent entries
in the Forwarding Table.
2. Configure the Speed/Duplex setting for the port. The
only option is 1000M/Full, which means port operation at
1000 Mbps in full duplex mode.
3. Configure the Flow Control setting for the port. Select
On for the switch to automatically negotiate the correct
flow control setting for this port. Select Off for no flow
control.
Web-Based Network Management
Gigabit Ethernet Switch User's Guide
79
Advertisement
Table of Contents
