Table of Contents
Advertisement
Figure 6-20. Firmware and Configuration Update screen
The fields you can set are:
♦ Software Update Mode Set to either Network or SLIP.
Determines whether the configuration file should be
obtained through the Ethernet network or through the
console port.
♦ TFTP Server Address The IP address of the TFTP server
where the configuration file is located. This entry is used
only if the Firmware Update is set to Enabled. If BOOTP
Service (see the IP Configuration screen under Configure
IP Address on the System Configuration menu) is set to
Enabled, the address will be obtained from the BOOTP
server.
♦ Firmware Update Determines whether or not the Switch
will try to look for a runtime image file over the network. If
set to Disabled, none of the fields below have any effect.
♦ File Name The pathname of the runtime image file on your
TFTP server to be downloaded.
Using the Console Interface
Gigabit Ethernet Switch User's Guide
57
Advertisement
Table of Contents
