Table of Contents
Advertisement
Gigabit Ethernet Switch User's Guide
onboard software and then begins to blink when performing
a self-test. After approximately 2 seconds, the LED light
again to indicate the ready state of the switch.
♦ Console This LED indicator is lit when the switch is being
managed via out-of-band/local console management through
the RS-232 console port using a straight-through serial
cable. When a secured connection is established, this LED
indicator is lit. Otherwise, it is OFF.
♦ Link/Act. These LED indicators are lighted up when there
is a secure connection (or link) to a device at any of the ports.
The LED indicators blink whenever there is reception or
transmission (i.e. Activity--Act) of data occurring at a port.
♦ Full These LED indicators are illuminated when a port is
operating in full-duplex mode.
14
Identifying External Components
Advertisement
Table of Contents
