FCC Warning This equipment has been tested and found to comply with the regulations for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
B O U T H I S U I D E This user’s guide tells you how to install your 5-Port 1000BASE-T Gigabit Ethernet Switch, how to connect it to your Gigabit Ethernet network. Terms For simplicity, this documentation uses the terms “Switch”...
N T R O D U C T I O N This section describes the features of the 5-Port 1000BASE-T Gigabit Ethernet Switch, as well as providing some background information about Gigabit Ethernet and switching technology. Gigabit Ethernet Technology Gigabit Ethernet is an extension of IEEE 802.3 Ethernet...
Switching LAN technology is a marked improvement over the previous generation of network bridges, which were characterized by higher latencies. Routers have also been used to segment local area networks, but the cost of a router and the setup and maintenance required make routers relatively...
Features The 5-Port 1000BASE-T Gigabit Ethernet Switch was designed for easy installation and high performance in an environment where traffic on the network and the number of users increase continuously. 5 1000BASE-T Gigabit Ethernet ports Supports Auto-Negotiation for 10/100/1000Mbps and...
Install the Switch in a site free from strong electromagnetic source,vibration, dust,and direct sunlight. Leave at least 10cm of space at the left and right hand side of the Switch for ventilation. Visually inspect the DC power jack and make sure that it is...
A description of these LED indicators follows (see LED Indicators). Rear Panel The rear panel of the Switch consists of an DC power connector. The following figure shows the rear panel of the Switch. Rear panel view of the Switch...
DC Power Jack: Power is supplied through an external AC power adapter. Check the technical specification section for information about the AC power input voltage. 1000BASE-T Ports: Five Gigabit Ethernet ports of 10/100/1000Mbps Auto-Negotiation interface. LED Indicators The LED indicators of the Switch include Power, Link/Act, 1000Mbps and 100Mbps.
Page 17
These LED indicators are lighted up when there is a secure connection (or link) to 1000Mbps Gigabit Ethernet device at the desired port. 100Mbps These LED indicators are lighted up when there is a secure connection (or link) to 100Mbps Fast Ethernet device at the desired port.
Page 19
E C H N I C A L P E C I F I C A T I O N S General Standards: IEEE 802.3ab 1000BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3 10BASE-T IEEE 802.3x Flow Control Protocol: CSMA/CD Data Ethernet:...
Page 20
0 °C ~ 40°C Temperature: Storage -10°C ~ 70°C Temperature: Humidity: 5% ~ 95% RH, non-condensing Dimensions: 171 x 98 x 29 mm (W x H x D) FCC Class A, CE Marking Class A, VCCI Certification: Class A Performance Transmission Store-and-forward Method:...
Need help?
Do you have a question about the TEG-S50TXE and is the answer not in the manual?
Questions and answers