Gl2: Unsup. Papr; No Data - Canon imagePROGRAF iPF510 User Manual

Messages regarding HP-GL/2
Messages regarding HP-GL/2

GL2: Unsup. papr

The printer has received a HP-GL/2 print job that
cannot be printed on the paper that has been
advanced.

No data.

The data was lost because of replotting.
GL2:Wxxxx (xxxx is 0501, 0903, or 0904)
The printer memory is full.
GL2:W0502
A parameter specied in a HP-GL/2 command is out
of the supported range.
GL2:W0504
The printer has received an unsupported HP-GL/2
command.
696 Error Message
Cause
Cause
Cause
Cause
Cause
Corrective Action
Replace the paper with a type compatible with
HP-GL/2. For details on paper compatible with
HP-GL/2, refer to the Paper Reference Guide.
(→P.103)
The printer may continue printing, but the printing
quality may be affected. Check the printing results.
Corrective Action
Data for replotting is lost after the following
operations. In this case, send the print job again.
•
The memory buffer was cleared from the Control
Panel.
•
The printer was turned off.
•
The printer received a new print job.
Corrective Action
Because the entire print job could not be received,
the printer may not be able to print the entire original.
Check the printing results.
Corrective Action
Check the print job.
Corrective Action
Check the print job.