Table of Contents
Advertisement
Configuration
5. Configuration
5.1. Connect to Configure
5.1.1. Connect to PC and Power
When configuring the Tunnel Gateway it must be connected to a PC.
Figure 6. Connect to PC and power
1.
Connect an Ethernet cable between one of the Tunnel Gateway LAN switch ports and your PC.
2.
Connect the Tunnel Gateway Power connector to a power supply.
SCM-1202-233 Version 1.0
®
Anybus
Tunnel Gateway
Page 11 of 45
Advertisement
Table of Contents
Need help?
Do you have a question about the Anybus AWB5300 and is the answer not in the manual?
Questions and answers