Table of Contents
Advertisement
Connection
5.2.6. Connection Procedure for Home Automation
Connect the Home Automation Ethernet cable to the gateway's Ethernet Port. The correct cable to use depends
on where the gateway is connected:
• Connecting directly to a Home Automation device: use a crossover Ethernet UTP/FTP CAT5 or higher cable.
• Connecting to a hub or switch of the LAN of the building: use a straight Ethernet UTP/FTP CAT5 or higher
cable.
NOTE
When commissioning the gateway for the first time, DHCP will be enabled for 30 seconds. During
that time, if there is a DHCP server, an IP address will be automatically assigned to the gateway. If
there is no DHCP, you can type an IP address of your choice. After that time, the default IP address
192.168.100.246 will be automatically set.
IMPORTANT
If communicating through the LAN of the building, contact the network administrator and make sure
traffic on the used port is allowed through all LAN paths.
NOTE
See the
Wiring diagram (page
5.2.7. Connection to a PC for Configuration
Use the supplied USB Mini-B type to USB Type-A cable to connect the gateway through its Console port to a PC
to configure it with Intesis MAPS.
NOTE
Find all you need to know about the gateway configuration and Intesis MAPS in the
Configuration Guide for
NOTE
See the
Wiring diagram (page
USER MANUAL Version 1.0.7
10).
IN775FGL00xO000.
10).
Fujitsu VRF systems with KNX, Serial and IP support
Intesis MAPS
Page 15 of 41
Advertisement
Table of Contents
