Getting Started With Pairing And Log In - HME NEXEO Instruction Manual

Getting Started with Pairing and Log In

P
airing
Before you can start using your system, you must first pair your headset with the Base Station. Pair-
ing links the headset to the Base Station, allowing it to recognize your headset and communicate with
it. The Base Station will sense when a headset is placed next to the blue pairing ring and will begin
pairing (see Fig. 1.19 ). Fig. 1.20 shows how the blue pairing ring responds once it senses a head-
set within range. The solid blue pairing ring turns to a swirling green ring indicating that pairing is in
progress. Pairing is complete and successful when the swirling green becomes a solid green circle.
Headset registration also happens automatically with the initial pairing of a headset.
If your headset has a low battery, a battery level low alert (
the situation before proceeding. Either charge the battery or replace it with a fully charged one.
NOTE: If pairing fails (indicated by a red swirling pairing ring), try again by holding the
headset steady, centered, and flush against the Headset Pairing Ring (headset
movement and distance from the Pairing Ring can cause pairing errors).
Pairing will also fail once the battery level drops to approximately 5% or below.
12
BASE STATION
Headset
Sensor
Fig. 1.19
BASE STATION
Fig. 1.20
HEADSET
Position keypad facing
the Base Station
Headset
Sensor
Solid Blue: Sensor
idle until headset is
sensed
Headset
Swirling Green
Pairing
Pairing in progress
Ring
Solid Green: Pairing
Headset
successful. Begin
Pairing
using headset
Ring
Headset
Swirling Red: Pairing
Pairing
unsuccessful. Try again
Ring
) is displayed prompting you to resolve
© 2024 HM Electronics, Inc. All rights reserved.