Headset (Hs7000) Overview - HME NEXEO Instruction Manual

Headset (HS7000) Overview

The AIO HS7000 Headset (Fig. 1.12) is an all-in-one wireless headset. It uses one BAT70 lithium-ion
battery. Under normal use, the headset will operate for approximately eight hours on a single battery
charge and will alert you when the battery charge is low.
HEADSET
Side View
Lane 1
Volume Up
Volume Down
Action
Icon Label Status LED Boom LED
Lane 1
Green
Lane 2
Red
Volume
Up
Volume
Down
Group/
Crew
Action
Notes: Both the Status and Boom LEDs flash slowly, alternating colors
LED indicates a low battery. The low battery Status LED is also accompanied by audio prompts.
Voice commands
: See "Voice Commands" on page 9
Audio Feedback
: The headset also provides audio feedback when specific functions are initiated.
Push-to-Talk mode
: Press and hold any audio key (L1, L2 or Group Chat) to use in this mode (there is an audible single-tone confir-
mation). Release to cease communication and exit this mode (there is an audible two-tone confirmation).
8
Status
Raised sections on
LED
the bezel allow users
to identify keys on
Lane 2
keypad by touch.
I = Lane 1
II = Lane 2
III = Group
o = Action
HME
Group Chat
Headset Keypad Reference Table
Status/Description
Tap to talk to lane 1. The Status LED flashes green while the Boom LED turns on solid
Green
green (with audible single-tone confirmation). Tap again to stop (two-tone confirmation).
Tap to talk to lane 2. The Status LED flashes red while the Boom LED turns on solid red
Red
(with an audible single-tone confirmation). Tap again to stop (with two-tone confirmation).
Tap to increase volume (the headset beeps become louder as confirmation). Press and
hold to maximize volume to loudest.
Tap to decrease volume (the headset beeps become quieter as confirmation). Press and
hold to minimize volume to quietest.
Tap for group chat. Both Status and Boom LEDs flash quickly, alternating red & green.
(with an audible single-tone confirmation). Tap again to stop (with two-tone confirmation).
The Status LED changes to a solid yellow in listen-only mode.
If the headset is set to answer phone calls. Tap once to answer, tap again to end call.
Press the 1 or 2 key twice to put the phone call on hold and talk to a respective lane.
Press 1 or 2 once followed by the Action key to return to call. Press again to end call.
Status
LED
Boom
LED
Fig. 1.12
when the headset needs to be paired. A yellow Status
.
Table 1.4
© 2024 HM Electronics, Inc. All rights reserved.
HEADSET
Front View
Battery Release
Latch (silver)
Power Button
(blue)
Earpad
BAT70 Battery
(not included)