Maintenance Mode; Initialization - Omron K3NP - 1998 Operation Manual

Maintenance Mode

6-3

Maintenance Mode

6-3-1 Maintenance Mode

6-3-2 Initialization

1, 2, 3...
The set values of the K3NP can be initialized in maintenance mode. The opera-
tions of the K3NP in this mode are described below.
· The K3NP will be in maintenance mode if the Mode and Shift Keys are pressed
simultaneously while the K3NP is turned on.
· The K3NP in maintenance mode will go into RUN mode if the Escape Key is
pressed.
Press the Mode and Shift Keys
while turning the K3NP on.
Maintenance mode
1 second
Follow the steps described below to reset the set values of the K3NP to factory-
set values.
1. Press the Mode and Shift Keys simultaneously while turning the K3NP on.
The mant maintenance mode setting will be displayed.
Set Value LED Display Model
2. Press the Mode Key for more than one second. The re-in initialization set-
ting will be displayed.
Set Value LED Display Model
3. Press the Up Key to display no .
Set Value LED Display Model
Power On
Press the Escape and Up
Keys for 1 second.
RUN mode
RUN mode
Setting mode
Basic Model
Basic Model
Basic Model
Section 6-3
Protect mode
91