Omron K3NP - 1998 Operation Manual page 74

Setting Mode
SETTING
Follow the steps described below to set the following.
EXAMPLE
(Assume that the decimal point is set between the 2nd and 3rd digit from the right in the
prescale menu.)
1, 2, 3...
H: 100.00
L: 1.00
Set Value LED Display Model
1. Press the Mode Key for more than one second while the opt option menu is
displayed. The aUg process time for averaging measured value setting will
appear.
Set Value LED Display Model
2. Repeatedly press the Mode Key until the lset.h H linear output range set-
ting is displayed.
Set Value LED Display Model
3. Press the Shift Key to display the prior set value 999.99 for changing. The
PROG indicator will flash.
Set Value LED Display Model
4. Press the Up and Shift Keys to set the value to 100.00 . The setting will be
validated automatically if no change is made for five seconds. The lset.h H
linear output range setting will be displayed again.
Note Press the Mode Key to enter the set value immediately. The next pa-
rameter will be displayed for setting.
Set Value LED Display Model
+
5. Press the Mode Key to display the lset.l L linear output range setting.
Set Value LED Display Model
Section 4-2
Basic Model
Basic Model
Basic Model
Basic Model
Basic Model
Basic Model
65