Omron K3NP - 1998 Operation Manual page 33

Cycle: f2
Performance Characteristics
Accuracy of measurement
Measurement range
Response time of HOLD input
Recovery time (T )
R
ON/OFF pulse width
Response time
Relay output
Comparative output 25 ms max.
---
BCD output
Linear output ---
Response Time of HOLD
Input
Menu
--- Max./Min. value display and reset
sUset (note 1) ( ) Set value bank no. of set values
HH set value
H set value
L set value
LL set value
Set value bank no. of prescale values
pscl
Prescaling value of input A
X (mantissa)
Y (exponent)
Decimal point position
Operating mode
setup
Input A sensor type
Input B sensor type
Time unit
Communications unit no. (note 1)
Baud rate (note 1)
Word length (note 1)
Stop bits (note 1)
Parity bits (note 1)
Output pattern (note 1)
opt
H linear output range (note 1)
L Linear output range (note 1)
Remote/Local programming (note 1)
24
± ±
0.08% rdg
20 ms to 3200 s
20 ms max.
20 ms min.
Sensor with transistor output: 9
Sensor with relay output: 15 ms min.
Transistor
output
20 ms max.
---
---
The response time of the HOLD input is the time required for the K3NP to
accept HOLD input after the HOLD input turns ON. This is illustrated in the
following diagram.
Available functions in this mode are indicated as "Yes" in the following table.
Function
Note 1. The availability of the parameters depends on the type of selected Output
Board.
2. The selected bank number will be displayed where the asterisk (
1 digit (ambient temperature: 23°C
m
s min.
Output configuration
BCD and
transistor output transistor output
35 ms max. 35 ms max.
Refer to page 93. ---
--- 40 ms max.
Displayed
Character
---
s.bank
sU*.hh
sU*. h
sU*. l
sU*.ll
p.bank
ps*.ax
ps*.ay
decp.*
func
ina
inb
time
u-no
bps
len
sbit
prty
c-out
lset.h
lset.l
r-l
Section 3-2
±
5°C)
Linear and Communication
and transistor
output
20 ms max.
---
---
Availability Reference
page
Yes 82
Yes 42
Yes 46
Yes
Yes
Yes 50
Yes 52
No
Yes 54
56
Yes
Yes
Yes 58
Yes
Yes
Yes 61
Yes 64
Yes
Yes 67
) appears.
*