Modes - Omron K3NP - 1998 Operation Manual

Modes

K3NP with RS-422 Output Board, K31-FLK3
Communications
Output Board
Terminator
K3NP with RS232C + Transistor Output Board, K31-FLK4
K3NP with RS-422 + Transistor Output Board, K31-FLK6
Communications
Output Board
Terminator
1-4

Modes

RUN Mode
The following four modes are available.
· RUN mode for normal operations (see Section 5 Operations in RUN Mode)
· Setting mode for initializing parameter input (see Section 4 Parameter Setting)
· Protect mode for lock-out configuration (see 4-1 Protect Mode)
· Maintenance mode for initialization (see 6-3-2 Initialization)
Refer to the following for the relationship among these modes and selection of
the modes.
Press the Mode and Shift Keys
while turning on the K3NP.
Maintenance mode
1 second
K3NP is in RUN when the K3NP is turned ON.
The K3NP in this mode provides an output signal as a result of the comparison of
the measured and setting values.
Input Board
Transistor
Output Board
Input Board
Power on
Press the Escape and up
Keys for 1 second.
RUN mode
RUN mode
Setting mode
Section 1-4
Protect mode
7