System Components - Omron CP1E - INTRODUCTION Introduction Manual

2-2-2 System Components

PLC
Equipment and Software for Programming
Inputs
Outputs
This section defines components to be used in the shutter control system. The
following components are to be used.
• CP1L (14-point I/O unit with AC power supply)
• CX-Programmer
• Computer
• USB cable (A-B)
• Shutter OPEN button : PB1 (A16-series, etc)
• Shutter STOP button : PB2 (A16-series, etc)
• Shutter CLOSE button : PB3 (A16-series, etc)
• Car detection sensor : SEN1 (E3G-series, etc)
• Headlight detection sensor : SEN2
• Limit switch, turned ON when shutter is fully open : LS1 (WL-series, etc)
• Limit switch, turned ON when shutter is fully closed : LS2 (WL-series, etc)
• Contact for activating the shutter escalation motor : MO1
• Contact for activating the shutter de-escalation motor : MO2
LS1
MO1
MO2
LS2
2-2 About the Shutter Control System
SEN2
PB1
SEN1
PB2
PB3
SYSMAC CP1L/CP1E Introduction Manual
2
2
25