Omron CP1E - INTRODUCTION Introduction Manual page 155

CP1W-CIF11/12 Setup
Set the DIP switches as follows.
(Rear panel)
No.
1 Presence of terminating resistance
2 2/4-wire selection
3 2/4-wire selection
4 -
5 RS control for RD
6 SD control for RD
V1000 Setup
Set the DIP switches as follows.
• SW2-1: ON (terminating resistance present) Terminating resistance for RS422/
485 communication
Next, set the parameters as follows:
No.
B1 02 Operation command
B1 01 Frequency command
C1 01 Acceleration time 1
C1 02 Deceleration time 1
H5 09 RS-422/485 communication
Timeout detection
U4 19 RS-422/485 communication
Frequency commands and
monitoring
H5 01 RS-422/485 communication
Slave address
H5 02 RS-422/485 communication
Baud rate
H5 03 RS-422/485 communication
Parity
H5 06 RS-422/485 communication
Transmission wait time
H5 07 RS-422/485 communication
RTS control
CPU unit connector
Operation setup
DIP switches
Setting
Name Value
2
6
5.0
5.0
1
1
1
2
0
10
0
A-4 CP1L Programming Examples
ON/OFF Content
ON Terminating
resistance
present
ON 2-wire type
ON 2-wire type
OFF Always OFF
ON Enabled
ON Enabled
Comments
RS-422/485 communication enabled
Frequency commands from RS-422/485
communication enabled
Acceleration time (sec)
Deceleration time (sec)
Detection enabled, detect errors, stop
deceleration after deceleration time 1 (Default)
Select unit for communication of frequency
commands data and frequency monitoring data.
Unit: 0.01Hz (Default).
Slave address (slave node number), unit 1
Communication baud rate (communication
speed): 9600bps (Default)
Even parity
Sets the response wait time for request messages
received from the master. 10ms (Default).
RTS control enabled (Default)
SYSMAC CP1L/CP1E Introduction Manual
A
153