Programming Flash Memory Using The Board Update Portal - Intel Cyclone V GT FPGA Development Kit User Manual

A. Programming the Flash Memory Device
792833 | 2024.02.21
10. After programming completes, if you have a software file to program, type the
following Nios II EDS command:
nios2-flash-programmer --base=0x00000000 <yourfile>_sw.flash
11. Set the SW4.3 DIP switch to the FACT OFF (logic 1) position and power cycle the
board.
Programming the board is now complete.
To restore flash memory, refer to Restoring the Flash Device to the Factory Settings.
For more information about the nios2-flash-programmer utility, refer to the Nios II
Flash Programmer User Guide.
Related Information
• Restoring the MAX V CPLD to the Factory Settings
• Creating Flash Files Using the Nios II EDS
• Restoring the Flash Device to the Factory Settings
• Nios II Flash Programmer User Guide
A.6. Programming Flash Memory Using the Board Update Portal
Once you have the necessary
reprogram the flash memory. Refer to Using the Board Update Portal to Write User
Designs for more information.
If you have generated a
still use the Board Update Portal to upload your design. In this case, leave the
Software File Name field blank.
Related Information
Using the Board Update Portal to Write User Designs
Send Feedback
on page 43
files, you can use the Board Update Portal to
.flash
that operates without a software design file, you can
.sof
on page 15
on page 16
on page 19
®
Cyclone V GT FPGA Development Kit User Guide
45