The Flash Tab - Intel Cyclone V GT FPGA Development Kit User Manual

6.3.3.4. Push Buttons
This control displays the current state of the board user push buttons. Press a push
button on the board to see the graphical display change accordingly.

6.3.4. The Flash Tab

The Flash tab allows you to read and write flash memory on your board. The following
figure shows the Flash tab.
Figure 9. The Flash Tab
Note: The picture of the development kit is only a reference and might be different from the latest one.
The following sections describe the controls on the Flash tab.
6.3.4.1. Read and Start Address
The Read control reads the flash memory on your board. To see the flash memory
contents, type a starting address in the Start address text box and click Read.
Values starting at the specified address appear in the memory table on the Flash tab.
6.3.4.2. Range
Range displays the entire range of the flash memory. If you enter an address outside
of the flash memory address space, a warning message identifies the valid flash
memory address range.
®
Cyclone V GT FPGA Development Kit User Guide
28
6. Board Test System
792833 | 2024.02.21
Send Feedback