Factory Default Switch And Jumper Settings - Intel Cyclone V GT FPGA Development Kit User Manual

Related Information

Factory Default Switch and Jumper Settings

4.2. Factory Default Switch and Jumper Settings
The following figure shows the default switch settings for the top side of the Cyclone V
GT FPGA development board.
Figure 2. Default Switch Settings on the Board Top
CLKSEL
CLKKEN
FACT
MODE
1
The following figure shows the default switch and jumper settings for the bottom side
of the Cyclone V GT FPGA development board.
®
Cyclone V GT FPGA Development Kit User Guide
12
User DP Switch
SW1
0
ON
1
1 0 2 3 4 5 6 7
SW3
SW4
0
4. Development Board Setup
on page 12
792833 | 2024.02.21
Send Feedback