Intel Cyclone V GT FPGA Development Kit User Manual page 14

Table 4. SW4 DIP Switch Settings
Switch Board Label
1 CLKSEL Switch 1 has the following options:
•
•
2 CLKEN —
3 FACT Switch 3 has the following options:
•
•
4 MODE Switch 4 is an optional user switch setting. It is not currently defined in the MAX
V system controller.
3. Set the DIP switch bank (SW5) to match SW5 DIP Switch Settings table and
Default Switch Settings on the Board Bottom figure.
Table 5. SW5 DIP Switch Settings
Switch Board Label
1 MSEL1 Switch 1 has the following options:
•
•
2 MSEL2 Switch 2 has the following options:
•
•
3 MSEL4 Switch 3 has the following options:
•
•
4 FAN Switch 4 has is an optional user switch setting. It is not currently defined in the
MAX V system controller.
For more information on the MSEL modes, refer to Cyclone V Device Handbook:
Volume 1: Device Interfaces and Integration.
4. Set the J17 jumper block to match J17 Jumper Block table and Default Switch
Settings on the Board Bottom figure. The
voltage to bank 7, which connects to the HSMB interface. By default this rail is 2.5
V. If needed, you can change the voltage level of this power supply by adding in a
jumper wire between the pins of J17 as indicated in J17 Jumper Block table and
Default Switch Settings on the Board Bottom figure.
Table 6. J17 Jumper Block
Note: Adding a single jumper between the pins sets the voltage as described in the table. Install only one
jumper location at a time.
Jumper
Pins 1-2
Pins 3-4
Pins 5-6
®
Cyclone V GT FPGA Development Kit User Guide
14
ON (logical 0) = SMA input clock select.
OFF (logical 1) = Programmable oscillator clock select.
ON (logical 0) = Load the factory design from flash at power up.
OFF (logical 1) = Load the user design from flash at power up.
When ON, a logic 0 is selected.
When OFF, a logic 1 is selected.
When ON, a logic 0 is selected.
When OFF, a logic 1 is selected.
When ON, a logic 0 is selected.
When OFF, a logic 1 is selected.
C5_VCCIO_VAR
1.8 V
1.5 V
1.2 V
Function
Function
C5_VCCIO_VAR
Not installed
Not installed
Not installed
4. Development Board Setup
792833 | 2024.02.21
Default
Position
OFF
ON
ON
ON
Default
Position
ON
OFF
OFF
OFF
power rail provides the
Default Position
Send Feedback