Installing A Backplane For Removable Tray - Siemens SIMATIC IPC RC-545A Operating Instructions Manual

4. Remove the unlatched backplane ④ from the brackets by turning it upwards and removing
it from the drive cage.
5. Close the device.
7.6.4.3

Installing a backplane for removable tray

The backplane of the removable tray is installed from inside at the back end of the drive cage
type A and is equipped with interfaces for data cables to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
Only use original spare parts or components approved for this device. You can find
information on this under "Hardware accessories (Page 33)".
Requirement
• You are familiar with the important safety instructions under "Safety instructions on
device and system extensions (Page 50)".
• The device is fully disconnected from the mains voltage, see "Switching off the device
(Page 72)".
Client SIMATIC IPC RC-545A
Operating Instructions, 03/2024, A5E53092314-AA
Expanding and assigning parameters to the device
7.6 Installing and removing drives in drive cages
99