Connecting A Usb Stick To The Internal Interface - Siemens SIMATIC IPC RC-545A Operating Instructions Manual

Expanding and assigning parameters to the device

7.4 Connecting a USB stick to the internal interface

7.4 Connecting a USB stick to the internal interface
You can connect a USB flash drive internally in the device. You can find the interfaces for this
on the motherboard (Page 151) at the rear of the device.
For this process, you will need a retainer for locking the internal USB interface.
Only use original spare parts or components approved for this device. You can find
information on this under "Hardware accessories (Page 33)".
Requirement
• You are familiar with the important safety instructions under "Safety instructions on
device and system extensions (Page 50)".
• The device is fully disconnected from the mains voltage, see "Switching off the device
(Page 72)".
• Screwdriver TORX T10
Procedure
1. Open the device. See the notes under "Open the device (Page 77)".
2. Insert the USB stick into the socket of the internal USB interface on the motherboard
(Page 151).
3. Screw the two hexagon bolts ① with two of the enclosed screws into the first and third drill
holes of the retainer.
4. Hold the retainer from the inside with the hexagon bolts on the rear panel of the device and
fasten the retainer from the outside with the remaining screws on the rear panel of the
device. You can find information on the position of the drill holes in section "Rear of the
device (Page 22)".
5. Slide the bar of the retainer ③ onto the USB stick.
86
Client SIMATIC IPC RC-545A
Operating Instructions, 03/2024, A5E53092314-AA