Installing A Backplane For Removable Tray - Siemens SIMATIC IPC647E Operating Instructions Manual

Expanding and assigning parameters to the device
6.6 Installing and removing drives
6.6.1.3

Installing a backplane for removable tray

The backplane of the removable tray is installed from inside at the back end of the drive cage
type A and is equipped with interfaces for data cables to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
Removable tray with backplane
Requirement
• You know the important safety instructions under "Safety instructions on device and
system extensions (Page 46)".
• An original replacement part. For information on replacement parts, refer to "Hardware
accessories (Page 31)".
• The device is equipped with the drive cage type A.
Procedure
1. Fully disconnect the device from the line voltage, see "Switching off the device (Page 66)".
2. Open the device. Be sure to follow the important instructions under "Open the device
(Page 97)".
118
Operating Instructions, 09/2022, A5E52254141-AA
SIMATIC IPC647E