Installing A 5.25" Drive Or 5.25" Component - Siemens SIMATIC IPC RC-545A Operating Instructions Manual

Expanding and assigning parameters to the device
7.6 Installing and removing drives in drive cages
11. Insert the drive cover ③ between the drive mounting bars ②. Ensure that the pins engage in
the openings on the left and right ⑦.
12. Push the drive bay in fully and evenly until you hear it click into the drive cage.
13. Connect the power and data cables to the drive.
14. Close the device.
7.6.5.3

Installing a 5.25" drive or 5.25" component

You can install 5.25" drives or other 5.25" components in type A and type B drive cages.
You can find notes on the mounting locations here:
• Drive cage type A (Page 17)
• Installation options for drives with drive cage type A (Page 91)
• Drive cage type B (Page 19)
• Installation options for drives with drive cage type B (Page 93)
Only use original spare parts or components approved for this device. You can find
information on this under "Hardware accessories (Page 33)".
Requirement
• You are familiar with the important safety instructions under "Safety instructions on
device and system extensions (Page 50)".
• The device is fully disconnected from the mains voltage, see "Switching off the device
(Page 72)".
• Screwdriver TORX T10
108
Client SIMATIC IPC RC-545A
Operating Instructions, 03/2024, A5E53092314-AA