Commissioning The Device; Switching On The Device; Configuring Automatic Switch-On Of Device - Siemens SIMATIC IPC RC-545A Operating Instructions Manual

Commissioning the device

5.1

Switching on the device

Requirement
• The power supply unit is connected. (Page 64)
Procedure
1. For devices with power supply unit 550 W:
Switch on the on-off switch on the rear of the device (position | ).
2. Press the on-off button on the front side of the device behind the front door.
Information on the position of the switch and the button is available under "Operator
controls (Page 26)".
Commissioning the installed Windows® operating system
You can find information on switching on the device for the first time and starting up the
installed Windows® operating system in the documentation for your operating system, see
"Important instructions and manuals for operating the device (Page 10)".
5.2

Configuring automatic switch-on of device

In the firmware settings, you can specify that the device starts up again automatically after
being disconnected from the mains voltage for up to two minutes as soon as the mains
voltage is available again.
The minimum downtime required for the mains voltage depends on the configuration of the
device.
Configure this function in the firmware settings:
1. Select: "Advanced > Power Management > Restore AC after Power Loss".
2. Assign the "Always on" value to the firmware setting "Restore AC after Power Loss".
See also
Important instructions and manuals for operating the device (Page 10)
Client SIMATIC IPC RC-545A
Operating Instructions, 03/2024, A5E53092314-AA
5
71