Removing A Backplane For Removable Tray - Siemens SIMATIC IPC RC-545A Operating Instructions Manual

Expanding and assigning parameters to the device
7.6 Installing and removing drives in drive cages
7.6.4.2

Removing a backplane for removable tray

The backplane of the removable tray is installed from inside at the back end of the drive cage
type A and is equipped with interfaces for data cables to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
Requirement
• You are familiar with the important safety instructions under "Safety instructions on
device and system extensions (Page 50)".
• The device is fully disconnected from the mains voltage, see "Switching off the device
(Page 72)".
Procedure
1. Open the device. See the notes under "Open the device (Page 77)".
2. Pull out both plugs ①.
3. Unlatch the backplane by firmly pressing on the latches ② in the direction of the arrow and
simultaneously pressing on the ejector ③.
98
Client SIMATIC IPC RC-545A
Operating Instructions, 03/2024, A5E53092314-AA