Ukca Marking; Fcc Rules (Usa) - Siemens SIMATIC IPC RC-545A Operating Instructions Manual

Standards and approvals
11.1 Certificates and approvals
11.1.4

UKCA marking

The device complies with the designated British standards (BS) for electrical equipment
published in the official consolidated list of the British Government. The device meets the
requirements and protection targets of the following regulations and related amendments:
• S.I. 2016 No. 1091
Electromagnetic Compatibility Regulations 2016 (S.I. 2016 No. 1091), and related
amendments
• S.I. 2012 No. 3032
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012 (S.I. 2012 No. 3032), and related amendments
• S.I. 2016 No. 1101
The Electrical Equipment (Safety) Regulations 2016 (S.I. 2016 No. 1101), and related
amendments
UKCA Declaration of Conformity
The associated declaration of conformity is available on the Internet at the following address:
• EU/UK Declaration of Conformity for SIMATIC IPC
(https://support.industry.siemens.com/cs/ww/en/view/37369031)
11.1.5

FCC Rules (USA)

Federal Communi-
cations Commis-
sion
Radio Frequency
Interference
Statement
Shielded Cables
Modifications
Conditions of
Operations
148
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communi-
cations. Operation of this equipment in a residential area is likely to cause harm-
ful interference in which case the user will be required to correct the interference
at his own expense.
Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
Changes or modifications not expressly approved by the manufacturer could void
the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Client SIMATIC IPC RC-545A
Operating Instructions, 03/2024, A5E53092314-AA