Installing A Backplane For Removable Tray - Siemens SIMATIC IPC847E Operating Instructions Manual

6.6.1.5

Installing a backplane for removable tray

The backplane is installed from inside at the back end of the drive cage type A and is
equipped with interfaces for data cable to the motherboard.
This enables the convenient connection of the data cables from the motherboard to the drive
in the removable tray at these interfaces.
Requirement
● The device is equipped with the type A drive cage, see "Permissible expansion for
temperature range 0 to 40 °C (Page 100)" and "Permissible expansion for temperature
range 0 to 50 °C (Page 102)".
● An original spare part, that is a backplane approved for this device, see notes in
"Hardware accessories (Page 30)".
● The device is fully disconnected from the line voltage, see "Switching off the device
(Page 60)".
● The device is open, see important information in "Open the device (Page 89)".
Procedure
1. Press the locks
2. Push the locks to the front in the direction of the arrow.
SIMATIC IPC847E
Operating Instructions, 10/2018, A5E43920357-AA
① ②
of the cover together inside the device and keep them pressed.
Expanding and assigning parameters to the device
6.6 Drives
109