Programming; L3Harris Device Management; Programming Via Rpm2 - L3Harris XL Series Operator's Manual

14221-1850-2000, Rev. C
6.

PROGRAMMING

This section provides information on front panel programming. Programming can also be
accomplished by creating a personality using a computer with RPM2 installed.
6.1

L3HARRIS DEVICE MANAGEMENT

L3Harris Device Management is a web-based application that allows the user to collect basic
status and version information, read and program personalities, and program firmware in XL
radios over LTE or secure Wi-Fi. Refer to the L3Harris Device Management User's Manual
14221-2100-2010 for information about using the application.
The radio only communicates with L3Harris Device Management when initiated by the user as
shown in the following steps:
1. From the radio menu select UTILITY  DEVICE MANAGEMENT.
2. Verify the CONNECTION STATUS is CONNECTED.
3. Highlight and select DM ACTIONS to check for available updates.
4. The DM ACTIONS menu displays CHECKING while searching for updates. This will change
to UPDATE AVAILABLE if there are available updates.
5. Select DOWNLOAD & INSTALL to install available updates.
6.2

PROGRAMMING VIA RPM2

Radio Personality Manager (RPM2) is used for radio programming. With RPM2, you can fully
program the radio using the USB programming cable.
NOTE
98
Ensure that the radio is turned off before connecting the programming cable. After
the cable is connected, power on the radio.