14221-1850-2000, Rev. C
4. Select an entry from the list of pre-programmed entries or click DIRECT DIAL KEYPAD to
enter the number directly. Direct Dial entries can have up to 31 characters (0-9, *, #, or a
space; the space correlates to a pause.) Select OPTIONS to view details about the highlighted
pre-programmed entry. The radio supports up to 255 pre-programmed entries.
5. Press PTT to initiate the phone call. Press the right navigation button to end the call.
The radio does not permit telephone interconnect calls during an emergency. While in a phone
call, the radio ignores all types of calls EXCEPT a System All Call. If the radio receives a System
All Call while in a phone call, it immediately drops the phone call and accepts the All Call.
4.23 DTMF
When a Keypad Mobile Microphone is connected, the XL Mobile Radios support the transmission
of DTMF tones corresponding to the numbers/characters on the keypad.
numbers/characters, press and hold the PTT button, and then press the corresponding keys one
at a time on the keypad. Valid keys for DTMF tones are: 1, 2, 3, 4, 5, 6, 7, 8, 9, *, 0, and #.
NOTE
4.24 START SCAN
This procedure assumes that the scan list has been added and the radio is not in active scan.
Refer to Section 5.13 for scan setup or Section 4.25 for stopping scan. Refer to Section 5.13.1.1,
Section 5.13.1.2, and Section 5.13.1.3 for home and priority channel descriptions.
To start scan:
1. Press the Menu button.
2. Navigate to the SCAN menu.
3. Scroll up or down to highlight START SCAN and press the Group/Channel Select Knob.
START SCAN text changes to STOP SCAN.
4. Press the BACK soft key to exit the scan menu.
56
For conventional or P25 Conventional systems, DTMF tones only play if the
current system is programmed for DTMF (part of general System configuration).
DTMF tones are always enabled for P25 Trunking systems.
To overdial