Table 11-1: Wi-Fi Feature Support - L3Harris XL Series Operator's Manual

Table of Contents

Read Single Personality

Read Multiple Personalities

Write Single Personality

Write Multiple Personalities

Load Single Code File

Load Multiple Code Files

Voice Annunciation

Feature Data

Radio Name

Install Splash Screen

6. In the Status Panel, all Wi-Fi related actions will have the prefix of "WIFI."

To help in displaying the radios, the "Connection" and "IP Address" columns are sortable.

If the Access Point is not configured to the default values from Section A.2 and the

active personality in the radio is removed, the radio loses connection to the Access

Point and must be connected over USB to write/activate a personality to reconnect

NOTE

to the Access Point.

A.7 RPM2 WI-FI SUPPORT FOR ENTERPRISE NETWORKS.

Enterprise Networks have certain limitations when it comes to Discovering/Programming Radios

in RPM2. There is a 4500 second (75 minute) caching affect inherent to implementation with the

Cisco

Wi-Fi solution that utilizes the Access Point (AP)/Wireless LAN Controller (WLC)

components. Radios remain 'seen' in RPM2 even after the radio leaves Wi-Fi or is turned off. It

is cached in RPM2 for 4500 seconds. This issue has only been observed with the Cisco AP and

WLC solution; however, other enterprise wireless solutions may observe this caching affect.

Operation with a lower tiered Wi-Fi router that does not operate with a WLC will likely not observe

this behavior.

See the Software Release Notes for Media Kit SK-019007-001 (14221-3100-8110) for more

information.

A.8 HELPFUL HINTS

A.8.1

Initial Setup and Configuration

Since radio discovery is dependent on if Multicast (mDNS) messages are being received by

RPM2, it is best to keep things as simple as possible. Here are the suggested steps if this is being

setup and configured for the first time.

1. Configure the Access Point with the default personality values provided in Section A.2.

2. Create a basic personality with a single system, set and channel, write it to the radio and

activate it over USB.

3. Complete Sections A.4 through A.6.